Walls are defined using the add wall tool, located
in the editor toolbar at the top of the
screen. Walls are defined by two or more points, which can be moved or
deleted at any time. After you select the first point, a banding line
follows your cursor indicating the wall orientation. In the middle
of the banding line is a text box that gives you dynamic feedback of the
length. Walls will snap to an angle in 45° increments. You
can override this behavior by turning of the Snap
Walls 90°
command.
Once the wall is drawn, you can drag any point to any distance or angle.
Click HERE to learn more about walls.
Note: Corner points can be added to a straight small segment by clicking on them while pressing the [Ctrl] key on the keyboard.